Les vidéos de Tommy Desrochers:

• ESP32 #1
• ESP32 #2
• ESP32 #3
• ESP32 #4
• ESP32 #5

Sous Debian 12, lors du 1er test, j'ai reçu ces deux messages d'erreur:

• Error Msg: ModuleNotFoundError: No module named 'serial'
• Error msg: Failed uploading: no upload port provided

On va donc, d'abord:

• # apt install python3-serial
• # /sbin/usermod -aG dialout <USER> + reboot

Suivi de l'installation proprement dite :

• Download Aduino IDE: https://www.arduino.cc/en/software
• Unzip : $ unzip arduino[…]
• Launch : $ cd arduino[…], $ ./arduino-ide
• Menu File → Preferences → Additional boards manager URLs: https://raw.githubusercontent.com/espressif/arduino-esp32/gh-pages/package_esp32_index.json
• Menu Tools → Board → Board Manager… → search with ESP32, select de most recent version of ESP32 by Espressif Systems, and Install
• Menu Tools → Board → Esp32 → ESP32 Dev Module
• Menu Tools → Port → /dev/ttyUSB0

• Menu File → example → ESP32 → ChipID → GetChipID
• Upload: Menu Sketch → Upload
• Menu Tools → Serial Monitor
• Change to 115200 Baud

ESP32 Chip model = ESP32-D0WDQ6 Rev 101
This chip has 2 cores
Chip ID: 11493932

void setup() { 
  Serial.begin(115200);
  while (!Serial) continue;
  Serial.println("Ready.");
} 
void loop() { 
}

[26/09/2014]

Suite illogique des pins GPIO

GPIO-1 en OUTPUT → conflit avec sortie serial

#include <math.h>
const float pi = 3.14159;
const int ledPin[7] = {5,18,19,21,3,22,23}; 
 
void setup() {  
  for (int i=0; i<7; i++) {
    pinMode (ledPin[i], OUTPUT);
  } 
} 
 
void loop() { 
  for (float ang=-pi; ang<pi; ang=ang+(2*pi/700)) {
    int led = (1+std::sin(ang))*7/2;
    digitalWrite (ledPin[led], HIGH);
    delay(1);
    digitalWrite (ledPin[led], LOW);
  }
}